Buy Now, Pay Later Starting at 0% APR
Ford Racing 11-14 Mustang GT 5.0L Manual Transmisson One Piece Aluminum Driveshaft Assembly Hellhorse Performance
Click to zoom in

*All images are for illustration purpose only. Actual product may vary
WARNING : Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
FOR CLOSED COURSE COMPETITION USE ONLY. NOT INTENDED FOR STREET USE. THE USE, OR INSTALLATION OF THIS PRODUCT MAY ALSO BE ILLEGAL NATIONWIDE UNDER THE FEDERAL CLEAN AIR ACT (42 U.S.C. § 7522(A)(3))

Ford Racing 11-14 Mustang GT 5.0L Manual Transmisson One Piece Aluminum Driveshaft Assembly

$796.00
Ford Racing 11-14 Mustang GT 5.0L Manual Transmisson One Piece Aluminum Driveshaft Assembly Fits 2011-2014 Mustang GT with a manual and automatic transmission. 1430 mm (56.299 inches) Overall length Measured from the face of transmission flange to face of the rear end flange  Direct bolt in right out of the box Designed for Increased Horsepower applications to deliver peak endurance and optimum strength  3.5-inch Diameter 6061-T6 Aluminum tubing with .125 inch wall thickness provides exceptional strength and reliability  1350 SERIES...
$796.00

customers are viewing this product

Ford Racing 11-14 Mustang GT 5.0L Manual Transmisson One Piece Aluminum Driveshaft Assembly

  • Fits 2011-2014 Mustang GT with a manual and automatic transmission.
  • 1430 mm (56.299 inches) Overall length
  • Measured from the face of transmission flange to face of the rear end flange 
  • Direct bolt in right out of the box
  • Designed for Increased Horsepower applications to deliver peak endurance and optimum strength 
  • 3.5-inch Diameter 6061-T6 Aluminum tubing with .125 inch wall thickness provides exceptional strength and reliability 
  • 1350 SERIES Dana-Spicer 5-1350X solid body Universal Joints...much stronger than the 1330 series versions available for Mustangs 
  • 1350 series flange yoke to bolt to the transmission 
  • 1350 series flange yoke to bolt to OE Mustang rear end flange...NO adapter required 
  • Fully Assembled and Balanced 
  • Spline and Slip design to allow for installation and suspension movement 
  • Hard Plastic boot to keep grease in and water out to protect spline and slip from contaminants 
  • Eliminates the need for a center support bearing 
  • Reduced overall weight and rotating mass delivers improved driving performance and provides quicker acceleration 
  • Off-Road Use Only
Read More
Read Less
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Your cart

×